Apache Technologies Bullseye 3 Manuel de l'opérateur télécharger pdf (Page 8)

Operation

Touch Panel

To turn the BULLSEYE 3

on, press the power switch on the touch

panel and release. All the LED's will come on for a few seconds. Each

LED

grade display row will turn on then turn off from top to bottom. Then

each status indicator

will tun on and off. The current deadband status will

momentarily display. If the receiver is out of the laser beam, the center

green LED will ﬂash to conﬁrm power is on. If the receiver is in a laser

beam, a corresponding LED grade display will be indicated.

To turn the receiver off, press the power switch for 2 seconds. All the

LED's will light. Releasing the switch will turn the power off.

Default Settings. Initially, the receiver is set from the factory to the

standard deadband and dim display. Additional functions are set to

Out of Beam indication on, Laser Out of Level warning off, and Laser

Beam Averaging on.

The following sections detail the operation of each these settings.

The receiver will subsequently power on with the same settings as

when it was turned off.

Display

Brightness

Switch

Deadband

Selection

Switch

Power Switch

Low Battery

Indicator

Deadband

Indicators

Unmarked

Switch

Unmarked

Switch

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Pas de commentaire

Apache Technologies Bullseye 3 Manuel de l'opérateur Page 8